Caproni Campini N.1
Caproni Campini N.1 | |
---|---|
![]() | |
A Caproni Campini N.1 in flight. Note the canopies left open to cool down the cockpit. | |
Role | Experimental aircraft |
National origin | Italy |
Manufacturer | Caproni |
Designer | Secondo Campini |
First flight | 27 August 1940 |
Status | Prototypes only |
Primary user | Regia Aeronautica |
Number built | 2 |
Developed into | Caproni Campini Ca.183bis |
The Caproni Campini N.1, also known as the C.C.2, was an experimental jet aircraft built in the 1930s by Italian aircraft manufacturer Caproni. The N.1 first flew in 1940 and was briefly regarded as the first successful jet-powered aircraft in history, before news emerged of the German Heinkel He 178's first flight a year earlier.[1]
During 1931, Italian aeronautics engineer Secondo Campini submitted his studies on jet propulsion, including a proposal for a so-called thermo-jet to power an aircraft.[2] Following a high-profile demonstration of a jet-powered boat in Venice, Campini was rewarded with an initial contract issued by the Italian government to develop and manufacture his envisioned engine. During 1934, the Regia Aeronautica (the Italian Air Force) granted its approval to proceed with the production of a pair of jet-powered prototype aircraft. To produce this aircraft, which was officially designated as the N.1, Campini formed an arrangement with the larger Caproni aviation manufacturer.
The N.1 was powered by a motorjet, a type of jet engine in which the compressor is driven by a conventional reciprocating engine. It was an experimental aircraft, designed to demonstrate the practicality of jet propulsion. On 27 August 1940, the maiden flight of the N.1 occurred at Caproni facility in Taliedo, outside of Milan, flown by renowned test pilot Mario de Bernardi. On 30 November 1941, the second prototype was flown by pilot De Bernardi and engineer Giovanni Pedace from Milan's Linate Airport to Rome's Guidonia Airport, in a highly publicised event that included a fly-past over Rome and a reception with Italian Prime Minister Benito Mussolini. Testing of the N.1 continued into 1943, by which point work on the project was disrupted by the Allied invasion of Italy.
The N.1 achieved mixed results, while it was perceived and commended as a crucial milestone in aviation (until the revelation of the He 178's earlier flight), the performance of the aircraft was underwhelming; specifically, it was slower than some existing conventional aircraft of the era, while the motorjet engine was incapable of producing sufficient thrust to deliver viable performance levels to be used in a fighter aircraft. Campini embarked on further projects (like the Reggiane Re.2007), but these would involve the indigenously-developed motorjet being replaced with a German-provided turbojet. As such, the N.1 programme never led to any operational combat aircraft, and the motorjet design was soon superseded by more powerful turbojets. Only one of the two examples of the N.1 to have been constructed has survived to the present day.
Development[]
During 1931, Italian aeronautics engineer Secondo Campini submitted a report to the Regia Aeronautica (the Italian Air Force) on the potential of jet propulsion; this report included his proposals for one such implementation, which he referred to as a thermo-jet. That same year, Campini established a company, with his two brothers, called the "Velivoli e Natanti a Reazione" (Italian for "Jet Aircraft and Boats") to pursue the development of this engine. In April 1932, the company demonstrated a pump-jet propelled boat in Venice, Italy. The boat achieved a top speed of 28 knots (32 mph; 52 km/h), a speed comparable to a boat with a conventional engine of similar output. The Italian Navy, who had funded the development of the boat, placed no orders but did veto the sale of the design outside of Italy.[2][3]
During 1934, the Regia Aeronautica granted approval for the development of a pair of prototypes, along with a static testbed, for the purpose of demonstrating the principle of a jet aircraft, as well as to explore potential military applications.[3] As his company lacked the necessary industrial infrastructure for such endeavours, Campini formed an arrangement with the larger Caproni aviation manufacturer, under which the latter provided the required material assistance for the manufacturing of the prototypes.[4] Under this relationship, Campini developed his design, which later received the official Italian Air Force designation of N.1.[5]
Historian Nathanial Edwards has contrasted the relative openness of Italian early jet development work against the high levels of secrecy present within other nation's programmes, such as Britain and Germany.[6] He speculated that this was due to desire of the Italian government to be perceived as possessing a modern and advanced aviation industry, being keen to acquire national prestige and adoration for such achievements. Edwards went onto claim that the practicality of the N.1 design was undermined by political pressure to speed the programme along so that Italy would be more likely to be the first country in the world to perform a jet-powered flight.[6]
Design[]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/0/06/Compressore_assiale_Campini.jpg/170px-Compressore_assiale_Campini.jpg)
The Caproni Campini N.1 was an experimental aircraft, designed to demonstrate the practicality of jet propulsion and its viability as an engine for aircraft.[citation needed] In terms of its basic configuration, it was composed entirely out of duralumin and had a monoplane layout, being outfitted with an elliptical wing. The initial aircraft lacked elements such as a pressurised cabin; however, these improvements were featured on the second prototype.[citation needed] However, flight testing quickly revealed that, due to the excessive heat output of the pioneering propulsion system, the canopy would have to be left permanently open as a mitigating measure.[7]
The engine of the N.1 featured a radical design, differing substantially from the later-produced turbojet and turbofan engines. One crucial difference in Campini's design was the compressor – a three-stage, variable-incidence one, located forward of the cockpit – was driven by a conventional piston engine, this being a 900 hp (670 kW), liquid-cooled Isotta Fraschini unit.[8] The airflow provided by the compressor was used to cool down the engine prior to being mixed with the engine's exhaust gases, thus recovering most of the heat energy that in traditional piston-propeller designs would be discharged overboard. A ring-shaped burner would then inject fuel into the gas flow and ignite it, immediately before the exhaust nozzle, to further increase thrust.[5][9]
In practice, the engine was able to provide sufficient thrust for flight even without activating the rear burner, making the design somehow similar to a ducted fan coupled with an afterburner.[7] Campini referred to this configuration as being a thermojet, although it has since become commonly known as motorjet.[10] However, despite the elaborate design, the relatively small size of the duct limited the mass flow and thus the propulsive efficiency of the engine. In modern designs this is offset through high overall pressure ratios, which could not be achieved on the N.1, therefore resulting in relatively low thrust and poor fuel efficiency.[11] Ground tests performed with the static testbed produced a thrust of around 700 kgf (1,500 lbf).[4]
Operational history[]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/3/33/Testing_the_Campini_Caproni.jpg/220px-Testing_the_Campini_Caproni.jpg)
On 27 August 1940, the N.1s first flight was made by test pilot Mario De Bernardi at Caproni's facility in Taliedo, outside of Milan. He was an accomplished aviation figure who had set several world records in seaplanes and aerobatic aircraft and would conduct the majority of the N.1's test flights.[12]
The first flight lasted ten minutes, during which de Bernardi kept the speed below 225 mph (362 km/h), less than half throttle.
Although the first flight of the jet-powered Heinkel He 178 had been made a year before, to the day, it had not been made public, so the Fédération Aéronautique Internationale recorded the N.1 as the first successful flight by a jet aeroplane.[4]
Flight tests with the first prototype revealed several issues with the engine. It didn't produce sufficient thrust to achieve the anticipated performance if it was matched to a strengthened airframe to withstand the high loading pressures.[5] The engine generated considerable heat, which forced the pilot to fly with the canopy open throughout the flight, which although effectively venting the heat, increased drag.[7] According to aviation author Sterling Michael Pavelec the N.1 was "heavy and underpowered" and the conventionally-powered Caproni Vizzola F.4 was faster which he attributed to limited national resources which left development programs underfunded.
![](http://upload.wikimedia.org/wikipedia/commons/thumb/5/5c/CC2_overflying_Piazza_Venezia_Rome_1941.jpg/220px-CC2_overflying_Piazza_Venezia_Rome_1941.jpg)
On 30 November 1941, the second prototype was flown by de Bernardi, with Giovanni Pedace as a passenger from Milan's Linate Airport to Rome's Guidonia Airport, in a highly publicised event that included a fly-past over Rome and a reception with Italian Prime Minister Benito Mussolini.[citation needed] It was the first cross-country jet flight. The flight included a stopover at Pisa, possibly to refuel, and was conducted without using the rear burner.[4][9]
A Soviet aircraft design bureau, TsAGI, obtained some details of the motorjet, and developed their own.[13] Campini later formed a partnership with another Italian aircraft company, Reggiane, and with Roberto Longhi, started a new design, the Reggiane Re.2007, which was intended from the outset to be a fighter, although he abandoned the Italian motorjet in favour of a German turbojet.[citation needed]
Testing of the two N.1 prototypes continued into 1943, however losing one of the N.1s when the Caproni factory was bombed, and the collapse of the Fascist government following the Allied invasion of Italy hindered the programme.[citation needed] After the defeat of Italy, one of the remaining prototypes was transported to the United Kingdom for study at the Royal Aircraft Establishment (RAE) in Farnborough. The fate of this aircraft remains unknown.[4]
Operators[]
Surviving aircraft[]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/1/1a/Campini-Caproni_C.C.2_2009-06-06.jpg/220px-Campini-Caproni_C.C.2_2009-06-06.jpg)
The surviving prototype is now on display at the Italian Air Force Museum at Vigna di Valle, near Rome, while the ground testbed, consisting of only the fuselage, is on display at the National Museum of Science and Technology in Milan.[14]
Specifications[]
Data from Illustrated Encyclopedia of Aircraft [15]
General characteristics
- Crew: 2
- Length: 13.1 m (43 ft 0 in)
- Wingspan: 15.85 m (52 ft 0 in)
- Height: 4.7 m (15 ft 5 in)
- Wing area: 36 m2 (390 sq ft)
- Empty weight: 3,640 kg (8,025 lb)
- Max takeoff weight: 4,195 kg (9,248 lb)
- Powerplant: 1 × motorjet , 6.9 kN (1,600 lbf) thrust consisting of a 670 kW (900 hp) Isotta Fraschini L.121 R.C.40 piston engine driving a three-stage, variable-pitch axial compressor with an afterburner
Performance
- Maximum speed: 375 km/h (233 mph, 202 kn)
- Service ceiling: 4,000 m (13,000 ft)
See also[]
Aircraft of comparable role, configuration, and era
Related lists
References[]
Citations[]
- ^ Enzo Angelucci; Paolo Matricardi. Campini Caproni C.C.2 in Guida agli Aeroplani di tutto il Mondo. Mondadori Editore. Milano, 1979. Vol. 5, pp. 218–219.
- ^ Jump up to: a b Buttler, Tony (2019-09-19). "Jet Propulsion". Jet Prototypes of World War II: Gloster, Heinkel, and Caproni Campini's wartime jet programmes. Bloomsbury Publishing. ISBN 978-1-4728-3597-0.
- ^ Jump up to: a b Alegi, Gregory (2014-01-15). "Secondo's Slow Burner, Campini Caproni and the C.C.2". The Aviation Historian. No. 6. United Kingdom. p. 76. ISSN 2051-1930.
- ^ Jump up to: a b c d e "Storia del Campini Caproni" (in Italian). National Museum of Science and Technology Leonardo da Vinci. Archived from the original on 15 July 2017. Retrieved 15 July 2017.
- ^ Jump up to: a b c Pavelec 2007, p. 5.
- ^ Jump up to: a b Edwards, Nathanial. "Flight as Propaganda in Fascist Italy." World At War Magazine, Late 2010.
- ^ Jump up to: a b c "Campini Caproni 2". Museo Storico di Vigna di Valle (in Italian). Aeronautic Militare Italiana. Archived from the original on 15 July 2017. Retrieved 16 July 2017.
- ^ Golly 1996, pp. 32–33.
- ^ Jump up to: a b Smith, Geoffrey (19 February 1942). "More About Jet Propulsion". Flight. Vol. XLI no. 1730. p. 153. Retrieved 16 July 2017.
- ^ Pavelec 2007, pp. 5–6.
- ^ Marc de Piolenc and George Wright, "Ducted Fan Design", Marc de Piolenc, 2001. p. 138.
- ^ "Italian Air Scooter". Flight, 10 October 1952. p. 471.
- ^ Mark 2014, p. 235.
- ^ Pavelec 2007, p. 6.
- ^ Morse, Stan, ed. (1982). Illustrated Encyclopedia of Aircraft. Orbis Publishing. OCLC 16544050.
Bibliography[]
- Golly, John. Jet: Frank Whittle and the Invention of the Jet Engine. Datum Publishing, 1996. ISBN 1-90747-201-0.
- Mark, Harrison. The Economics Of Coercion And Conflict. World Scientific, 2014. ISBN 9-81458-335-9.
- Morse, Stan. Illustrated Encyclopedia of Aircraft. Orbis Publishing, 1982.
- Pavelec, Sterling Michael. The jet race and the Second World War. Praeger Security International: Westport, Connecticut. 2007. ISBN 0-275-99355-8.
External links[]
![]() |
Wikimedia Commons has media related to Caproni Campini N.1. |
- Caproni aircraft
- 1940s Italian experimental aircraft
- Motorjet-powered aircraft
- Low-wing aircraft
- World War II Italian experimental aircraft
- World War II jet aircraft of Italy
- Aircraft first flown in 1940