Close-space sublimation
Closed space sublimation is a method of producing thin-films, esp. cadmium telluride photovoltaics, though it is used for other materials like antimony triselenide.[1]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/3/36/Example_of_a_Close_Space_Sublimation_setup.png/220px-Example_of_a_Close_Space_Sublimation_setup.png)
It is a type of physical vapor deposition where the substrate to be coated and the source material are held close to one another. They are both placed in a vacuum chamber, which is pumped down. The source and substrate are then heated. The source is heated to some fraction of its melting temperature, and the substrate some lower temperature e.g. 750 °C and 550 °C, respectively.[citation needed] This causes sublimation of the source, allowing vapors to travel a short distance to the substrate, where they condense, producing a thin film. This short-path diffusion is similar in principle to short-path distillation. Compared to other techniques, it is a relevantly insensitive process, and takes as little as 10 min for an entire cycle.[citation needed] This makes it a very viable technique for large-scale manufacturing.[2]
References[]
- ^ Birkett, Max; Linhart, Wojciech; Stoner, Jessica; Phillips, Laurie (24 May 2018). "Band gap temperature-dependence of close-space sublimation grown Sb2Se3 by photo-reflectance". APL Materials. 6 (8): 084901. doi:10.1063/1.5027157.
- ^ Potamialis, C.; Lisco, F. "Fabrication of CdTe Thin Films by Close Space Sublimation" (PDF). Centre for Doctoral Training New and Sustainable Photovolatics. Centre for Renewable Energy Systems Technology (CREST), Wolfson School, Loughborough University. Retrieved 26 April 2019.
- Thin film deposition
- Semiconductor device fabrication