Diisopropyl ether

From Wikipedia, the free encyclopedia
Diisopropyl ether
Diisopropyl ether.svg
Names
Preferred IUPAC name
2-[(Propan-2-yl)oxy]propane
Other names
Isopropyl ether
2-Isopropoxypropane
Diisopropyl oxide
DIPE
Identifiers
3D model (JSmol)
ChEMBL
ChemSpider
ECHA InfoCard 100.003.237 Edit this at Wikidata
EC Number
  • 203-560-6
RTECS number
  • TZ5425000
UNII
UN number 1159
  • InChI=1S/C6H14O/c1-5(2)7-6(3)4/h5-6H,1-4H3 checkY
    Key: ZAFNJMIOTHYJRJ-UHFFFAOYSA-N checkY
  • InChI=1/C6H14O/c1-5(2)7-6(3)4/h5-6H,1-4H3
    Key: ZAFNJMIOTHYJRJ-UHFFFAOYAC
  • O(C(C)C)C(C)C
Properties
C6H14O
Molar mass 102.177 g·mol−1
Appearance Colorless liquid
Odor Sharp, sweet, ether-like[1]
Density 0.725 g/ml
Melting point −60 °C (−76 °F; 213 K)
Boiling point 68.5 °C (155.3 °F; 341.6 K)
2 g/L at 20 °C
Vapor pressure 119 mmHg (20°C)[1]
-79.4·10−6 cm3/mol
Hazards
GHS labelling:
GHS02: FlammableGHS07: Exclamation markGHS08: Health hazard
Signal word
Danger
H225, H316, H319, H335, H336, H361, H371, H412
P201, P202, P210, P233, P240, P241, P242, P243, P260, P261, P264, P270, P271, P273, P280, P281, P303+P361+P353, P304+P340, P305+P351+P338, P308+P313, P309+P311, P312, P332+P313, P337+P313, P370+P378, P403+P233, P403+P235, P405, P501
NFPA 704 (fire diamond)
1
3
1
Flash point −28 °C (−18 °F; 245 K)
443 °C (829 °F; 716 K)
Explosive limits 1.4–7.9%
Lethal dose or concentration (LD, LC):
LD50 (median dose)
8470 mg/kg (rat, oral)[2]
LDLo (lowest published)
5000-6500 mg/kg (rabbit, oral)[2]
LC50 (median concentration)
38,138 ppm (rat)
30,840 ppm (rabbit)
28,486 ppm (rabbit)[2]
NIOSH (US health exposure limits):
PEL (Permissible)
TWA 500 ppm (2100 mg/m3)[1]
REL (Recommended)
TWA 500 ppm (2100 mg/m3)[1]
IDLH (Immediate danger)
1400 ppm[1]
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N  (what is checkY☒N ?)
Infobox references

Diisopropyl ether is secondary ether that is used as a solvent. It is a colorless liquid that is slightly soluble in water, but miscible with organic solvents. It is used as an extractant and an oxygenate gasoline additive. It is obtained industrially as a byproduct in the production of isopropanol by hydration of propylene.[3] Diisopropyl ether is sometimes represented by the abbreviation DIPE.

Uses[]

Whereas at 20 °C, diethyl ether will dissolve 1% by weight water, diisopropyl ether only dissolves 0.88%. Diisopropyl ether is used as a specialized solvent to remove or extract polar organic compounds from aqueous solutions, e.g. phenols, ethanol, acetic acid. It has also been used as an antiknock agent.

Safety[]

Diisopropyl ether can form explosive peroxides upon standing in air for long periods. This reaction proceeds more easily than for ethyl ether, due to the secondary carbon next to the oxygen atom. Antioxidants can be used to prevent this process. The stored solvent should therefore be tested for the presence of peroxides more often. It is recommended once every 3 months for diisopropyl ether compared to once every 12 months for ethyl ether.[4] Peroxides may be removed by shaking the ether with an aqueous solution of iron(II) sulfate or sodium metabisulfite.[5][6] For safety reasons, methyl tert-butyl ether is often used as an alternative solvent.

See also[]

References[]

  1. ^ a b c d e NIOSH Pocket Guide to Chemical Hazards. "#0362". National Institute for Occupational Safety and Health (NIOSH).
  2. ^ a b c "Isopropyl ether". Immediately Dangerous to Life or Health Concentrations (IDLH). National Institute for Occupational Safety and Health (NIOSH).
  3. ^ Sakuth, Michael; Mensing, Thomas; Schuler, Joachim; Heitmann, Wilhelm; Strehlke, Günther; Mayer (2010). "Ethers, Aliphatic". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a10_023.pub2.
  4. ^ "Organic Peroxides - Hazards : OSH Answers". www.ccohs.ca. Canadian Centre for Occupational Health and Safety, Government of Canada.
  5. ^ Chai, Christina Li Lin; Armarego, W. L. F. (2003). Purification of laboratory chemicals. Oxford: Butterworth-Heinemann. p. 176. ISBN 978-0-7506-7571-0.
  6. ^ Hamstead, A. C. (1964). "Destroying Peroxides of Isopropyl Ether". Industrial and Engineering Chemistry. 56 (6): 37-42. doi:10.1021/ie50654a005.

External links[]

Retrieved from ""