Mercedes-Benz M23 engine

The Mercedes-Benz M23 engine is a naturally-aspirated, 1.3-liter, inline-4 gasoline engine, designed, developed and produced by Mercedes-Benz; between 1933 and 1936.^{[2][3][4][5][6][7][8][9]}

Development and prototype engines (W17/W25D)[]

At the beginning of the 1930s, there were attempts to move car engines from the forward compartment to the rear of the car. Such a move allows a reduction in the volume of the front compartment. At the same time, the voluminous rear provides a lot of space above and behind the rear axle. Moreover, when engines are rear-mounted, the drive shaft is eliminated.

In 1930, Daimler-Benz entrusted Hans Nibel with the development of a small rear-engined car, starting from the same principles. In 1931, working with Max Wagner, the type W17 or 120(H) was created, a two-door, equipped with a four-cylinder boxer engine in the rear with a displacement of 1200 cc and a power of 25 hp (18.4 kW). There were also attempts with transverse four-cylinder inline engines. In 1932/1933 Mercedes built a prototype with a front similar to the later VW Beetle, and a longer tail.^[10]

Mercedes-Benz 130 (W23) engine[]

Created in 1931 by Nibel, it had the 1.3 liter sidevalve^[11] four-cylinder engine mounted at the back, hence the "H", from German heck (rear),^[12] With the fan between the rear coil springs,^[13] it drove a transmission with three forward speeds, plus a semi-automatic overdrive which did not require the use of a clutch.^[11]

Mercedes-Benz 150 (W30) engine[]

It was derived in 1935 from the 130, and a more powerful engine. Displacing 1498 cc and a power of 55 PS (40 kW). The engine powered the car to a top speed of 125 km/h.

Created in 1934 by Nibel and chassis engineer Max Wagner.^[12] the 150H was a two-seat sports roadster.^[12] It featured transverse leaf spring front and coil-sprung swing axle rear suspension. A water-cooled 1,498 cc (91.4 cu in) OHC four-cylinder engine, producing 55 hp (41 kW), was mounted in back, hence the "H", from German heck (rear).^[12] The radiator was behind that, above the transaxle, with a squirrel-cage blower^[12] (reminiscent of the VW Type 1) feeding both radiator and carburetor.^[12]

The gas tank, which in the case of the Mercedes-Benz 130 was installed over the engine, was transferred to the front compartment.

Mercedes-Benz 170 H (W28) engine[]

In 1936, in parallel to the classical front-engine Mercedes-Benz 170 V, Daimler-Benz AG introduced the Mercedes-Benz 170 H which had the same engine as the 170 V, with an architecture derived from the one of the 130, its predecessor. The 170 H was powered by a four-cylinder 1697 cc engine with a power of 38 PS (28 kW). The "H" stood for "Heckmotor", or rear engine.^[14]

Applications[]

• Mercedes-Benz 130
• Mercedes-Benz 150
• Mercedes-Benz 170 H

References[]