Formula Student
![]() | This article needs additional citations for verification. (June 2018) |
Formula Student | |
---|---|
![]() Sheffield Formula Racing en-route to winning 8 trophies at FSUK 2021 | |
Frequency | Annually |
Location(s) | Circuit of Silverstone |
Country | United Kingdom |
Formula Student is a student engineering competition held annually in the UK. Student teams from around the world design, build, test, and race a small-scale formula style racing car. The cars are judged on a number of criteria as listed below. It is run by the Institution of Mechanical Engineers and uses the same rules as the original Formula SAE with supplementary regulations.
Ambassadors of Formula Student include David Brabham, Paddy Lowe, Willem Toet, Leena Gade, Dallas Campbell, Mike Gascoyne, and James Allison.
Formula Student partnered with Racing Pride in 2019 to support greater inclusivity across the British motorsport industry for LGBT+ fans, employees and drivers.[1]
Class definitions[]
There are two entry classes in Formula Student, designed to allow progressive learning.
Formula Student Class (formerly Class 1)[]
This is the main event, where teams compete with the cars they have designed and built. Teams are judged across 6 categories and must pass a rigorous inspection by judges before being allowed to compete for the dynamic events. There are usually 100-120 teams in this class.
Concept Class (formerly Class 2)[]
This is a concept class for teams who only have a project and plan for a Class 1 car. It can include any parts or work that has been completed in the project so far but this is not necessary. Teams are judged on business presentation, cost and design. Schools can enter both FS Class and Concept Class cars, allowing Concept Class to be used for inexperienced students to practise their development in advance of a full Formula Student Class entry.
Class 1A (pre-2012)[]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/f/fa/Dut13.jpg/220px-Dut13.jpg)
This was an alternative fueled class with the emphasis placed upon the environmental impact of racing. A car from the previous year's Class 1 entry could be re-entered and re-engineered allowing the students to concentrate on the low carbon aspect of the competition without having to redesign a new chassis and ancillaries. Cars in Class 1A were judged in the same events alongside Class 1 however the cost category was replaced by one for sustainability and the endurance event had a greater emphasis placed upon measured emissions. Class 1A cars were scored and ranked independently of Class 1. Since 2012, both Petroleum and Alternative fueled cars have competed for places in the same rankings.
Class 2A (pre-2012)[]
This was a concept class for teams who only had a project and plan for a Class 1A car. It could include any physical parts or work that had been completed for the project so far, but was not essential. Teams were judged on business presentation, cost and design. Schools could enter both Class 1A and Class 2A teams, with Class 2A allowing inexperienced students to gain competition experience in preparation for a full Class 1A entry.
Judging[]
The cars are judged by industry specialists on the following criteria:
Static events[]
- Engineering design (175 points)
- Cost & Manufacturing (120 points)
- Business presentation (120 points)
- Technical inspection (comprising 6 tests): safety, chassis, noise, tilt, brake, and tech (no points)
Dynamic events[]
- Skidpad (figure of 8) (75 points)
- 1 km autocross/sprint (100 points)
- 75 m acceleration (75 points)
- 22 km endurance (250 points) and fuel economy (100 points)
The winner of the event is the team with the highest number of points out of a maximum of 1000.[2]
Venues[]
The first event was held at the Motor Industry Research Association (MIRA) proving ground in 1998. Following that, the event was held for three years at the NEC Birmingham between 1999 and 2001. The event was then held on the Go-Kart track at Bruntingthorpe Aerodrome between 2002 and 2006, before moving to Silverstone Circuit in 2007 where the competition remains until this day. The dynamic events have taken place on Luffield and Brooklands corners in the past but 2012 saw Copse corner and the National Circuit pit straight being used.
Winners[]
Most wins[]
Support[]
- Patron: Ross Brawn (former team principal of Mercedes Formula One team),
- Ambassador: The Rt Hon Lord Drayson of Kensington (Former Minister of Science)
Notable judges[]
- Carroll Smith
- Jon Hilton - Flybrid systems, ex Renault F1
- Andrew Deakin - Renault F1
- Chief Judge - Richard Folkson, ex Ford
- Neil Anderson
- Alex Snook - Aptiv
- Willem Toet - Sauber F1
- Alex Hickson - GKN Aerospace Filton UK
- Dan Jones - Flybrid Systems
- Allan Staniforth
- David Gould - Gould Racing
- Pat Clarke
- Nick Vaughan
- Matt Wilkin - Brawn GP
- Ben Michell - Dunlop Tyres
- Claude Rouelle - Optimum G
See also[]
- Formula SAE
- Formula SAE Australasia
- IIT Bombay Racing
- University of Patras Formula Student Team - UoP Racing Team
- ETSEIB Motorsport
- DJS Racing
References[]
- ^ "Racing Pride join Formula Student". www.imeche.net. Institution of Mechanical Engineers. 5 August 2019.
- ^ Formula Student 2021 Rules
External links[]
- Sheffield Formula Racing
- Cardiff Racing
- Formula Student
- Oxford Brookes Racing
- PWR Racing Team
- Southampton Formula Student Team
- Swansea University Race Engineering
- IIT Bombay Racing
- Team Bath Racing
- Team Kratos Racing Electric
- UH Racing
- University of Birmingham Racing
- University of Portsmouth's Formula Student Team
- UCD Formula Student
- Automotive engineering
- Engineering education in the United Kingdom
- Formula SAE
- Institution of Mechanical Engineers
- Motorsport in the United Kingdom
- Student competitions
- Student sport in the United Kingdom
- Formula racing