Serpent (cipher)

This article needs additional citations for verification. Please help by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources:  –  ·  ·  · scholar · JSTOR (April 2014) (Learn how and when to remove this template message)

Serpent

Serpent's linear mixing stage
General
Designers	Ross Anderson, Eli Biham, Lars Knudsen
First published	1998-08-21
Derived from	Square
Certification	AES finalist
Cipher detail
Key sizes	128, 192 or 256 bits
Block sizes	128 bits
Structure	Substitution–permutation network
Rounds	32
Best public cryptanalysis
All publicly known attacks are computationally infeasible, and none of them affect the full 32-round Serpent. A 2011 attack breaks 11 round Serpent (all key sizes) with 2116 known plaintexts, 2107.5 time and 2104 memory (as described in[1]). The same paper also describes two attacks which break 12 rounds of Serpent-256. The first requires 2118 known plaintexts, 2228.8 time and 2228 memory. The other attack requires 2116 known plaintexts and 2121 memory but also requires 2237.5 time.

Serpent is a symmetric key block cipher that was a finalist in the Advanced Encryption Standard (AES) contest, where it was ranked second to Rijndael. Serpent was designed by Ross Anderson, Eli Biham, and Lars Knudsen.

Like other AES submissions, Serpent has a block size of 128 bits and supports a key size of 128, 192 or 256 bits.^[2] The cipher is a 32-round substitution–permutation network operating on a block of four 32-bit words. Each round applies one of eight 4-bit to 4-bit S-boxes 32 times in parallel. Serpent was designed so that all operations can be executed in parallel, using 32 bit slices. This maximizes parallelism, but also allows use of the extensive cryptanalysis work performed on DES.

Serpent took a conservative approach to security, opting for a large security margin: the designers deemed 16 rounds to be sufficient against known types of attack, but specified 32 rounds as insurance against future discoveries in cryptanalysis. The official NIST report on AES competition classified Serpent as having a high security margin along with MARS and Twofish, in contrast to the adequate security margin of RC6 and Rijndael (currently AES).^[3] In final voting, Serpent had the fewest negative votes among the finalists, but scored second place overall because Rijndael had substantially more positive votes, the deciding factor being that Rijndael allowed for a far more efficient software implementation.^{[citation needed]}

The Serpent cipher algorithm is in the public domain and has not been patented.^[4] The reference code is public domain software and the optimized code is under GPL.^[5] There are no restrictions or encumbrances whatsoever regarding its use. As a result, anyone is free to incorporate Serpent in their software (or hardware implementations) without paying license fees.

Key Schedule[]

The Seprent key schedule consists of 3 main stages. In the first stage the key in initialized by adding padding if necessary. This is done in order to make short keys map to long keys of 256-bits, one "1" bit is appended to the end of the short key followed by "0" bits until the short key is mapped to a long key length.^[2]

In the next phase, the "prekeys" are derived using the previously initialized key. 32-bit key parts or XORed, the FRAC which is the fraction of the Golden ratio and the round index is XORed with the key parts, the result of the XOR operation is rotated to left by 11. The FRAC and round index were added to achieve an even distribution of the keys bits during the rounds.^[2]

Finally the "subkeys" are derived from the previously generated "prekeys". This results in a total of 33 128-bit "subkeys".^[2]

At the end the round key or "subkey" are placed in the "initial permutation IP" to place the key bits in the correct column.^[2]

Key Schedule pseudo code[]

#define FRAC 0x9e3779b9     //  fractional part of the golden ratio
#define ROTL(A, n) (A << n) | (A >> (32 - n))

uint32_t words[132]; // w
uint32_t subkey[33][4] // sk

/* key schedule: get prekeys */
void w(uint32_t *w) {
	for (short i = 8; i < 140; i++) {
		w[i] = ROTL((w[i - 8] ^ w[i - 5] ^ w[i - 3] ^ w[i - 1] ^ FRAC ^ (i - 8)), 11);
	}
}

/* key schedule: get subkeys */
void k(uint32_t *w, uint32_t (*sk)[4]) { 

	uint8_t i, p, j, s, k;
	
	for (i = 0; i < 33; i++) {
		p = (32 + 3 - i) % 32;
		for (k = 0; k < 32; k++) {
			s = S[p % 8][((w[4 * i + 0] >> k) & 0x1) << 0 |
						 ((w[4 * i + 1] >> k) & 0x1) << 1 |
						 ((w[4 * i + 2] >> k) & 0x1) << 2 |
						 ((w[4 * i + 3] >> k) & 0x1) << 3 ];
			for (j = 0; j < 4; j++) {
				sk[i][j] |= ((s >> j) & 0x1) << k;
			}
		}
	}
}

S-Boxes[]

The Serpent s-boxes are 4-bit permutations, and subject to the following properties:

• a 1-bit input difference will never lead to a 1-bit output difference, a differential characteristic has a probability of 1:4 or less.^[6]

• linear characteristics have a probability between 1:2 and 1:4, linear relationship between input and output bits has a probability between 1:2 and 1:8.^[6]

• the nonlinear order of the output bits as function of the input bits is 3. However there have been output bits found which in function of the input bits have an order of only 2.^[6]

The Serpent s-boxes have been constructed based on the 32 rows of the DES s-boxes. These were transformed by swapping entries, resulting arrays with desired properties were stored as the Serpent s-boxes. This process was repeated until a total of 8 s-boxes were found. The following key was used in this process: "sboxesforserpent".^[2]

Permutations and Transformations[]

Initial permutation (IP)[]

The initial permutation works on 128 bits at a time moving bits around.

for i in 0 .. 127
    swap( bit(i), bit((32 * i) % 127) )

Final permutation (FP)[]

The final permutation works on 128 bits at a time moving bits around.

for i in 0 .. 127
    swap( bit(i), bit((2 * i) % 127) )

Linear transformation (LT)[]

Consists of XOR, S-Box, bit shift left and bit rotate left operations. These operations are performed on 4 32-bit words.

for (short i = 0; i < 4; i++) {
    X[i] = S[i][B[i] ^ K[i]];
}
X[0] = ROTL(X[0], 13);
X[2] = ROTL(X[2], 3 );
X[1] = X[1] ^ X[0] ^ X[2];
X[3] = X[3] ^ X[2] ^ (X[0] << 3);
X[1] = ROTL(X[1], 1 );
X[3] = ROTL(X[3], 7 );
X[0] = X[0] ^ X[1] ^ X[3];
X[2] = X[2] ^ X[3] ^ (X[1] << 7);
X[0] = ROTL(X[0], 5 );
X[2] = ROTL(X[2], 22);
for (short i = 0; i < 4; i++) {
    B[i + 1] = X[i];
}

Rijndael vs. Serpent[]

Rijndael is a substitution-linear transformation network with ten, twelve, or fourteen rounds, depending on the key size, and with key sizes of 128 bits, 192 bits, or 256 bits, independently specified. Serpent is a substitution–permutation network which has thirty-two rounds, plus an initial and a final permutation to simplify an optimized implementation. The round function in Rijndael consists of three parts: a nonlinear layer, a linear mixing layer, and a key-mixing XOR layer. The round function in Serpent consists of key-mixing XOR, thirty-two parallel applications of the same 4×4 S-box, and a linear transformation, except in the last round, wherein another key-mixing XOR replaces the linear transformation. The nonlinear layer in Rijndael uses an 8×8 S-box whereas Serpent uses eight different 4×4 S-boxes. The 32 rounds means that Serpent has a higher security margin than Rijndael; however, Rijndael with 10 rounds is faster and easier to implement for small blocks.^[7] Hence, Rijndael was selected as the winner in the AES competition.

Serpent-0 vs. Serpent-1[]

The original Serpent, Serpent-0, was presented at the 5th workshop on Fast Software Encryption, but a somewhat tweaked version, Serpent-1, was submitted to the AES competition. The AES submission paper discuss the changes, which include key-scheduling differences.

Security[]

The XSL attack, if effective, would weaken Serpent (though not as much as it would weaken Rijndael, which became AES). However, many cryptanalysts believe that once implementation considerations are taken into account the XSL attack would be more expensive than a brute force attack.^{[citation needed]}

In 2000, a paper by Kohno et al. presents a meet-in-the-middle attack against 6 of 32 rounds of Serpent and an amplified boomerang attack against 9 of 32 rounds in Serpent.^[8]

A 2001 attack by Eli Biham, and Nathan Keller presents a linear cryptanalysis attack that breaks 10 of 32 rounds of Serpent-128 with 2¹¹⁸ known plaintexts and 2⁸⁹ time, and 11 rounds of Serpent-192/256 with 2¹¹⁸ known plaintexts and 2¹⁸⁷ time.^[9]

A 2009 paper has noticed that the nonlinear order of Serpent S-boxes were not 3 as was claimed by the designers.^[6]

A 2011 attack by Hongjun Wu, Huaxiong Wang and Phuong Ha Nguyen, also using linear cryptanalysis, breaks 11 rounds of Serpent-128 with 2¹¹⁶ known plaintexts, 2^107.5 time and 2¹⁰⁴ memory.^[1]

The same paper also describes two attacks which break 12 rounds of Serpent-256. The first requires 2¹¹⁸ known plaintexts, 2^228.8 time and 2²²⁸ memory. The other attack requires 2¹¹⁶ known plaintexts and 2¹²¹ memory but also requires 2^237.5 time.

See also[]

• Tiger – hash function by the same authors

Footnotes[]

Further reading[]

• Anderson, Ross; Biham, Eli; Knudsen, Lars (1998). "Cryptography – 256 bit ciphers: Reference (AES submission) implementation".
• Biham, Eli. "Serpent – A New Block Cipher Proposal for AES".
• Halbfinger, David M (5 May 2008). "In Pellicano Case, Lessons in Wiretapping Skills". The New York Times.
• Stajano, Frank (10 February 2006). "Serpent reference implementation". University of Cambridge Computer Laboratory.

External links[]

• Official website
• 256 bit ciphers – SERPENT Reference implementation and derived code