Supershear earthquake

From Wikipedia, the free encyclopedia

In seismology, a supershear earthquake is an earthquake in which the propagation of the rupture along the fault surface occurs at speeds in excess of the seismic shear wave (S-wave) velocity. This causes an effect analogous to a sonic boom.[1]

Rupture propagation velocity[]

During seismic events along a fault surface the displacement initiates at the focus and then propagates outwards. Typically for large earthquakes the focus lies towards one end of the slip surface and much of the propagation is unidirectional (e.g. the 2008 Sichuan and 2004 Indian Ocean earthquakes).[2] Theoretical studies have in the past suggested that the upper bound for propagation velocity is that of Rayleigh waves, approximately 0.92 of the shear wave velocity.[3] However, evidence of propagation at velocities between S-wave and compressional wave (P-wave) values have been reported for several earthquakes[4][5] in agreement with theoretical and laboratory studies that support the possibility of rupture propagation in this velocity range.[6][7]

Occurrence[]

Mode-I, Mode-II, and Mode-III cracks.

Evidence of rupture propagation at velocities greater than S-wave velocities expected for the surrounding crust have been observed for several large earthquakes associated with strike-slip faults. During strike-slip, the main component of rupture propagation will be horizontal, in the direction of displacement, as a Mode II (in-plane) shear crack. This contrasts with a dip-slip rupture where the main direction of rupture propagation will be perpendicular to the displacement, like a Mode III (anti-plane) shear crack. Theoretical studies have shown that Mode III cracks are limited to the shear wave velocity but that Mode II cracks can propagate between the S and P-wave velocities[8] and this may explain why supershear earthquakes have not been observed on dip-slip faults.

Initiation of supershear rupture[]

The rupture velocity range between those of Rayleigh waves and shear waves remains forbidden for a Mode II crack (a good approximation to a strike-slip rupture). This means that a rupture cannot accelerate from Rayleigh speed to shear wave speed. In the "Burridge–Andrews" mechanism, supershear rupture is initiated on a 'daughter' rupture in the zone of high shear stress developed at the propagating tip of the initial rupture. Because of this high stress zone, this daughter rupture is able start propagating at supershear speed before combining with the existing rupture.[9] Experimental shear crack rupture, using plates of a photoelastic material, has produced a transition from sub-Rayleigh to supershear rupture by a mechanism that "qualitatively conforms to the well-known Burridge-Andrews mechanism".[10]

Geological effects[]

The high rates of strain expected near faults that are affected by supershear propagation are thought to generate what is described as pulverized rocks. The pulverization involves the development of many small microcracks at a scale smaller than the grain size of the rock, while preserving the earlier fabric, quite distinct from the normal brecciation and cataclasis found in most fault zones. Such rocks have been reported up to 400 m away from large strike-slip faults, such as the San Andreas Fault. The link between supershear and the occurrence of pulverized rocks is supported by laboratory experiments that show very high strain rates are necessary to cause such intense fracturing.[11]

Examples[]

Directly observed[]

Inferred[]

See also[]

References[]

  1. ^ Levy D. (December 2, 2005). "A century after the 1906 earthquake, geophysicists revisit 'The Big One' and come up with a new model". Press release. Stanford University.
  2. ^ McGuire J.J., Zhao L. & Jordan T.H. (2002). "Predominance of Unilateral Rupture for a Global Catalog of Large Earthquakes" (PDF). Bulletin of the Seismological Society of America. 92 (8): 3309–3317. doi:10.1785/0120010293.
  3. ^ Broberg K.B (1996). "How fast can a crack go?". Materials Science. 32: 80–86. doi:10.1007/BF02538928. S2CID 120086779.
  4. ^ a b Archuleta,R.J. 1984. A faulting model for the 1979 Imperial Valley earthquake, J. Geophys. Res., 89, 4559–4585.
  5. ^ Ellsworth,W.L. & Celebi,M. 1999. Near Field Displacement Time Histories of the M 7.4 Kocaeli (Izimit), Turkey, Earthquake of August 17, 1999, Am. Geophys. Union, Fall Meeting Suppl. 80, F648.
  6. ^ Okubo P.G. (1989). "Dynamic rupture modeling with laboratory-derived constitutive relations". Journal of Geophysical Research. 94 (B9): 12321–12335. Bibcode:1989JGR....9412321O. doi:10.1029/JB094iB09p12321.
  7. ^ Rosakis A.J.; Samudrala O.; Coker D. (1999). "Cracks Faster than the Shear Wave Speed". Science. 284 (5418): 1337–1340. Bibcode:1999Sci...284.1337R. doi:10.1126/science.284.5418.1337. PMID 10334984. S2CID 29883938.
  8. ^ Scholz, Christopher H. (2002). The mechanics of earthquakes and faulting. Cambridge University Press. pp. 471. ISBN 978-0-521-65540-8.
  9. ^ Rosakis, A.J.; Xia, K.; Lykotrafitis, G.; Kanamori, H. (2009). "Dynamic Shear Rupture in Frictional Interfaces: Speed, Directionality and Modes". In Kanamori H. & Schubert G. (ed.). Earthquake Seismology. Treatise on Geophysics. Vol. 4. Elsevier. pp. 11–20. doi:10.1016/B978-0-444-53802-4.00072-5. ISBN 9780444534637.
  10. ^ Xia, K.; Rosakis, A.J.; Kanamori, H. (2005). "Supershear and sub-Rayleigh to Supershear transition observed in laboratory earthquake experiments" (PDF). Experimental Techniques. Retrieved 28 April 2012.
  11. ^ Doan M.-L.; Gary G. (2009). "Rock pulverization at high strain rate near the San Andreas fault" (PDF). Nature Geoscience. 2 (10): 709–712. Bibcode:2009NatGe...2..709D. doi:10.1038/ngeo640.
  12. ^ a b [1] Bouchon, M., M.-P. Bouin, H. Karabulut, M. N. Toksöz, M. Dietrich, and A. J. Rosakis (2001), How Fast is Rupture During an Earthquake ? New Insights from the 1999 Turkey Earthquakes, Geophys. Res. Lett., 28(14), 2723–2726.]
  13. ^ Bouchon M.; Vallee M. (2003). "Observation of Long Supershear Rupture During the Magnitude 8.1 Kunlunshan Earthquake". Science. 301 (5634): 824–826. Bibcode:2003Sci...301..824B. doi:10.1126/science.1086832. PMID 12907799. S2CID 26437293.
  14. ^ a b Walker, K.T.; Shearer P.M. (2009). "Illuminating the near-sonic rupture velocities of the intracontinental Kokoxili Mw 7.8 and Denali fault Mw 7.9 strike-slip earthquakes with global P wave back projection imaging" (PDF). Journal of Geophysical Research. 114 (B02304): B02304. Bibcode:2009JGRB..114.2304W. doi:10.1029/2008JB005738. Retrieved 1 May 2011.
  15. ^ Dunham E.M.; Archuleta R.J. (2004). "Evidence for a Supershear Transient during the 2002 Denali Fault Earthquake" (PDF). Bulletin of the Seismological Society of America. 92 (6B): S256–S268. doi:10.1785/0120040616.
  16. ^ Wang, D.; Mori J. (2012). "The 2010 Qinghai, China, Earthquake: A Moderate Earthquake with Supershear Rupture". Bulletin of the Seismological Society of America. 102 (1): 301–308. Bibcode:2012BuSSA.102..301W. doi:10.1785/0120110034. Retrieved 24 April 2012.
  17. ^ Wang D., Mori J. Uchide T. (2012). "Supershear rupture on multiple faults for the Mw 8.6 Off Northern Sumatra, Indonesia earthquake of April 11, 2012". Geophysical Research Letters. 39 (21): L21307. Bibcode:2012GeoRL..3921307W. doi:10.1029/2012GL053622.
  18. ^ Yue H., Lay T. Freymuller J.; et al. (2013). "Supershear rupture of the 5 January 2013 Craig, Alaska (Mw 7.5) earthquake". Journal of Geophysical Research. 108 (11): 5903–5919. Bibcode:2013JGRB..118.5903Y. doi:10.1002/2013JB010594. S2CID 3754158.
  19. ^ Evangelidis C.P. (2014). "Imaging supershear rupture for the 2014 M w 6.9 Northern Aegean earthquake by backprojection of strong motion waveforms". Geophysical Research Letters. 42 (2): 307–315. Bibcode:2015GeoRL..42..307E. doi:10.1002/2014GL062513.
  20. ^ Sangha S.; Peltzer G.; Zhang A.; Meng L.; Liang C.; Lundgren P.; Fielding E. (2017). "Fault geometry of 2015, Mw7.2 Murghab, Tajikistan earthquake controls rupture propagation: Insights from InSAR and seismological data". Earth and Planetary Science Letters. 462: 132–141. Bibcode:2017E&PSL.462..132S. doi:10.1016/j.epsl.2017.01.018.
  21. ^ Hicks, Stephen P.; Okuwaki, Ryo; Steinberg, Andreas; Rychert, Catherine A.; Harmon, Nicholas; Abercrombie, Rachel E.; Bogiatzis, Petros; Schlaphorst, David; Zahradnik, Jiri; Kendall, J-Michael; Yagi, Yuji (2020-08-10). "Back-propagating supershear rupture in the 2016 Mw 7.1 Romanche transform fault earthquake". Nature Geoscience. 13 (9): 647–653. doi:10.1038/s41561-020-0619-9. ISSN 1752-0894. S2CID 221111789.
  22. ^ Kehoe, H. L.; Kiser, E. D. (9 April 2020). "Evidence of a Supershear Transition Across a Fault Stepover". Geophysical Research Letters. 47 (10). doi:10.1029/2020GL087400.
  23. ^ Bao, Han; Ampuero, Jean-Paul; Meng, Lingsen; Fielding, Eric J.; Liang, Cunren; Milliner, Christopher W. D.; Feng, Tian; Huang, Hui (4 February 2019). "Early and persistent supershear rupture of the 2018 magnitude 7.5 Palu earthquake". Nature Geoscience. 12 (3): 200–205. doi:10.1038/s41561-018-0297-z. S2CID 133771692.
  24. ^ Tadapansawut, Tira; Okuwaki, Ryo; Yagi, Yuji; Yamashita, Shinji (16 January 2021). "Rupture Process of the 2020 Caribbean Earthquake Along the Oriente Transform Fault, Involving Supershear Rupture and Geometric Complexity of Fault". Geophysical Research Letters. 48 (1). doi:10.1029/2020GL090899.
  25. ^ Song,S. Beroza,G.C. & Segall,P. 2005. Evidence for supershear rupture during the 1906 San Francisco earthquake. Eos.Trans.AGU, 86(52), Fall Meet.Suppl., Abstract S12A-05
  26. ^ Zhongwen Zhan; Peter M. Shearer; Hiroo Kanamori (2015). "Supershear rupture in the 24 May 2013 Mw 6.7 Okhotsk deep earthquake: Additional evidence from regional seismic stations". Geophysical Research Letters. 42 (19): 7941-7948. doi:10.1002/2015GL065446.
  27. ^ "M 7.2 - 16 km WSW of Uglegorsk, Russia". earthquake.usgs.gov. Retrieved 20 August 2021.
  28. ^ "Researchers find evidence of super-fast deep earthquake". Phys.org. July 10, 2014. Retrieved July 10, 2014.

External links[]

Retrieved from ""