Two-cent billon

Two-cent billon

United states
Value	0.02 U.S. Dollar
Mass	3.84 g
Composition	90% Cu, 10% Ag
Years of minting	1836
Mint marks	None, all were minted at the Philadelphia Mint
Obverse
Design	Eagle
Designer	Christian Gobrecht
Design date	1836
Reverse
Design	Denomination surrounded by a wreath
Designer	Christian Gobrecht
Design date	1836

The two-cent billon was a pattern US coin struck in 1836 and initially proposed as part of the Act of January 13, 1837.^[1] Versions exist with either a reeded edge and coin orientation or a plain edge and medal orientation; however, those with the former tend to be original strikes, whereas the latter are always proof restrikes (most from the 1850s).^[2]

Background[]

A two-cent piece had been proposed as early as 1806 by Connecticut Senator Uriah Tracy, along with a twenty-cent piece or "double dime". Reflecting the then-prevalent view that coins should contain their value in metal, Tracy's bill provided that the two-cent piece be made of billon, or debased silver. The proposed metal would have consisted of 6.4 grains of silver and 24.3 grains of copper.^[3] The Mint Director at the time Robert Patterson opposed the bill, as it would be difficult to refine the silver from melted-down pieces. Tracy's legislation failed in the House of Representatives, despite passing in the Senate twice.^[4]

Inception[]

The Mint considered a two-cent piece again for the second time in 1836. Second Engraver Christian Gobrecht and Melter and Refiner Franklin Peale both conducted experiments for the coin, and concluded that the piece was to be made of billon (similar to the 1806 proposal). Although the coin was proposed in early drafts of the Mint Act of 1837, this the proposal was dropped when Peale showed that the coin could be easily counterfeited.^[5]

Aftermath[]

A two cent piece was proposed for a third time during the economic turmoil of the American Civil War, due to a national coin shortage. For the most part, the lack of coins was filled by private token issues, some were struck in copper-nickel approximating the size of the cent and others were thinner pieces in bronze.^[6]

This fact did not escape government officials, and in 1863, the use of bronze coins was proposed, as they did not seem to contain their face values in metal. In his annual report submitted October 1, 1863, Mint Director James Pollock noted that "whilst people expect a full value in their gold and silver coins, they merely want the inferior [base metal] money for convenience in making exact payments".^[7] He observed that the private cent tokens had sometimes contained as little as a fifth of a cent in metal, yet had still circulated. He proposed that the copper-nickel cent be replaced with a bronze piece of the same size.^[8] Pollock also wanted to eliminate nickel as a coinage metal; its hard alloys destroyed dies and machinery.^[9] On December 8, Pollock wrote to Treasury Secretary Salmon P. Chase, proposing a bronze cent and two-cent piece, and enclosing pattern coins of the two-cent piece that he had had prepared.^[10] According to numismatist Neil Carothers, a two-cent piece was most likely proposed in order to get as much dollar value in small change into circulation in as short a time as possible, as the Mint could strike a two-cent piece as easily as a cent.^[11]

The bronze two-cent piece eventually became a regular issue, but with declining mintage numbers each year until it was discontinued officially in 1873.

Varieties[]

References[]