Guangzhou–Zhuhai railway

Guangzhou–Zhuhai railway
Route map of Guangzhou–Zhuhai railway
Overview
Status	Operational
Termini	Jiangcun
Service
Type	Heavy rail
History
Opened	29 December 2012
Technical
Line length	189 km (117 mi)
Track gauge	1,435 mm (4 ft 8+1⁄2 in) standard gauge
Electrification	50 Hz 25,000 V
Operating speed	120 km/h (75 mph)

Guangzhou–Zhuhai railway (Chinese: 广珠铁路) is a railway between Jiangcun (Chinese: 江村) in Guangzhou and (Chinese: 高栏港) in Zhuhai, via the cities of Foshan and Jiangmen, in Guangdong, China. Opened at the end of 2012, it is currently used for freight only.

Role[]

Until the 21st century, Zhuhai did not have any railway connections to the rest of the country. Now, however, there are two new railways there: besides the Guangzhou–Zhuhai railway for freight trains, the passenger-only Guangzhou–Zhuhai intercity railway, is a passenger-only line, started construction in 2005 and was to be completed in 2010.^[1] Since the intercity rail will take up the role of the passenger service between Guangzhou and Zhuhai, this can explain why Guangzhou–Zhuhai railway will not be routed via Guangzhou City Area.^[2]

History[]

This railway project was approved by the State Development Planning Commission in 1993. The construction originally started in 1997, but it was stopped later due to lack of funds. Construction was resumed in 2007; at the time, it was expected to be completed in 2011.^[3][4] However, work did not proceeded as fast as expected; as of December 2011, it was reported that although most of the critical components of the project was completed, there was still about 100 m to go at the Jiangmen tunnel (see below), and the Jiangbei Bridge was still under construction.^[5]

In mid-October 2012, it was reported that the construction work has been essentially completed.^[6] The railway opened for freight traffic on December 30, 2012.^[7]

Infrastructure[]

The line has a total length of 189 kilometres (117 mi) and a maximum speed of 120 kilometres per hour (75 mph). Between Jiangcun and Jiangmen, the line is double-track. From Jiangmen to , the line is single-track. The entire line is electrified with provisions to allow for operating double-stack container trains.^[8]

Jiangmen tunnel[]

Constructing the railway involved digging a 9185 m long tunnel in Jiangmen. By May 2010, over half of the tunnel had been dug, and the entire tunnel was expected to be completed by the end of February 2011.^[9] However, as of December 2011, it was reported that the workers still had about 100 m to go.^[5]

Future[]

The railway is expected to carry passenger services in the future.

Nansha Port railway[]

A branch from ,^[10] the Nansha Port railway, will link the line with Nansha port and will also carry passengers to Nansha railway station.

References[]